Doktek Technology
ADDRESS: Merkezefendi / Denizli, Türkiye
Machines made in Türkiye
EN

Doktek Technology · November 15, 2026

When edge quality deteriorates in fiber laser cutting, the cause is often an incorrect setting or missed maintenance. The table below outlines common problems, possible causes and the initial checks to make.

Sheet metal cutting on a Doktek fiber laser cutting machine

Common cutting problems

ProblemPossible causesInitial checks and actions
Burrs on the bottom edgeIncorrect focus, unsuitable speed, low gas pressure or damaged nozzleCheck focus, speed and pressure; replace the nozzle
Burning or excessive oxidation on the edgeSpeed too low, power too high or oxygen pressure too highIncrease speed, reduce power or lower pressure
Failure to cut through the sheet or an interrupted cutInsufficient power, excessive speed, incorrect focus or dirty protective windowReduce speed, check focus, and clean or replace the window
Angled or uneven edgeBeam off-center in the nozzle, or nozzle tilted or damagedCenter the beam and replace the nozzle
Dimensional errors or offset featuresPlay in linear guides or racks, or incorrect calibrationCheck mechanical clearances and calibrate the machine
Spatter during piercingUnsuitable piercing parametersAdjust piercing time, power and height

Correct settings vary with the machine, laser power, material and thickness. Begin by checking your machine's cutting parameter chart.

If the problem persists

If adjustments and basic maintenance do not resolve the problem, the optics, cutting head, laser source or motion system need a more detailed inspection. Professional service support is recommended at this stage.

FAQs

YOUR QUESTIONS ANSWERED

What causes burrs in laser cutting?

The most common causes are incorrect focus, unsuitable cutting speed, low gas pressure and a damaged nozzle.

Why won't the machine cut through the sheet?

Power may be too low or speed too high. An incorrect focus setting or dirty protective window can also prevent the cut.

Knowledge center

MORE ARTICLES

Get a quote for your machine. Tell us what you need, and we'll work with you to define the right configuration.