Doktek Technology
ADDRESS: Merkezefendi / Denizli, Türkiye
Machines made in Türkiye
EN

Doktek Technology · November 15, 2026

Regular maintenance preserves cut quality and reduces faults and unplanned downtime on a fiber laser cutting machine. The checklist below is a general guide. Adapt maintenance intervals to the manufacturer's instructions and your machine's workload.

Doktek fiber laser cutting machine and control computer

Daily checks

  • Inspect the nozzle; clean or replace it if blocked or damaged.
  • Inspect the protective window; clean or replace it if dirty or scratched.
  • Check cutting gas pressure and the cylinder or tank level.
  • Check the chiller's water level, temperature and alarm status.
  • Remove slag and scrap from the cutting area.

Weekly checks

  • Clean linear guides and racks, then lubricate them as specified by the manufacturer.
  • Remove slag from the cutting bed slats and replace worn slats.
  • Check the fume extraction filters.
  • Inspect cables, hoses and the cable carrier for wear or binding.

Monthly checks

  • Check beam centering and focus settings.
  • Check the cutting head's height sensor and connections.
  • Check chiller filters and water quality.
  • Clean electrical panel fans and air filters.

Scheduled maintenance

Tasks such as changing chiller water, thoroughly inspecting optics, adjusting mechanical clearances and updating software are scheduled according to operating hours. Use the pure water specified by the chiller manufacturer, whether deionized or distilled.

This checklist is general guidance. Follow the maintenance instructions and intervals in your machine's manual.

FAQs

YOUR QUESTIONS ANSWERED

When should the protective window be replaced?

A dirty, scratched or burned protective window reduces cut quality and can damage the cutting head. Replace it if it cannot be cleaned.

Can we carry out maintenance ourselves?

A trained operator can handle most daily and weekly checks. Professional service support is recommended for beam centering, optics replacement and electrical or electronic work.

Knowledge center

MORE ARTICLES

Get a quote for your machine. Tell us what you need, and we'll work with you to define the right configuration.