A fast, trouble-free installation of a fiber laser cutting machine depends largely on what is prepared before the machine arrives. If the power supply, compressed air, assist gas, floor and ventilation are ready, the machine is cutting within a short time; every missing item delays commissioning. The list below summarises what to prepare in your workshop once the order is placed.
Start with location and floor
Choose the location based on how sheets will reach the machine, where cut parts will go and how much space remains around the machine for maintenance.
- The floor must be level, solid and free of vibration. For machines with a heavy frame, the floor's load capacity and, where needed, a concrete foundation are agreed before installation.
- Leave enough space around the machine to open the doors, carry out maintenance and load sheets; on machines with an exchange table, allow for the direction in which the table travels out.
- Plan the route for bringing sheets in by forklift or crane, and the area where cut parts will be stacked.
- Place the machine away from dust, moisture and direct sunlight, in an area with a temperature that is as stable as possible.
Power: a balanced three-phase supply and good grounding
Fiber laser cutting machines run on a three-phase supply. Because the laser source, servo motors, chiller and fume extraction draw power together, cable cross-section and circuit protection must match the machine's total power; the machine manufacturer provides the correct values.
- A dedicated distribution board and a dedicated line are recommended; heavy loads such as welding machines and compressors should not share the same line.
- Grounding must be measured and adequate. Poor grounding can cause hard-to-explain faults in the CNC and the laser source.
- If the mains suffers frequent voltage fluctuations or outages, consider a voltage stabiliser or an uninterruptible power supply (UPS).
- The electrical connection must be made by a qualified electrician.
Compressed air and assist gas
The cutting head uses oxygen, nitrogen or compressed air to blow the molten metal out of the cut. The gas you cut with determines both cut quality and the equipment you need to install.
- Oxygen and nitrogen are supplied from cylinders, cylinder bundles or a tank. Plan where the cylinders will stand, how they are secured and how the gas line is run to the machine.
- If you cut with air, the compressor's capacity and pressure must be suitable for laser cutting. The air must be dry, oil-free and well filtered, which requires a dryer and filters.
- Apart from the assist gas, the machine's pneumatic components may also need clean compressed air.
Chiller and ambient temperature
The chiller keeps the laser source and the cutting head at a constant temperature. Leave space around it for air circulation and use the coolant recommended by the manufacturer.
- If the workshop temperature approaches freezing in winter, take measures to keep the coolant from freezing; frozen coolant can damage the laser source and the cutting head.
- In very hot and humid conditions the risk of condensation on optical components increases, which is why workshop ventilation and temperature matter.
Fume extraction and safety
Laser cutting produces metal vapour and fine dust. These fumes must be collected by the machine's extraction system and passed through a filter unit or discharged appropriately.
- Plan the position of the extraction duct and the filter unit together with the position of the machine.
- On open-type machines, use suitable laser safety glasses and screens against the laser beam; on enclosed machines, the cabin provides most of this protection.
- Keep a suitable fire extinguisher near the machine and do not leave flammable material in the cutting area.
Installation day and after
Once preparation is complete, the machine is set in place and levelled, the power, gas and air connections are made, and commissioning and test cuts follow. If operators learn basic operation, daily checks and how to replace consumables such as nozzles and protective windows at this stage, problems in the early weeks are greatly reduced.
Doktek Technology installs and commissions the fiber laser cutting machines it manufactures in Denizli and provides spare parts and service support. Share your workshop's power supply and the space reserved for the machine before ordering, and we will finalise the preparation list together.
