In fiber laser cutting, the beam melts the metal and the assist gas blows molten material out of the kerf. Gas selection directly affects cutting speed, edge quality and operating costs.
Oxygen (O₂)
Oxygen is the most common gas for cutting mild steel (carbon steel). It reacts with the hot metal, adding heat to the process so thicker material can be cut at lower laser power and gas pressure. However, it leaves a thin oxide layer on the cut edge, which may need cleaning before painting or welding.
Nitrogen (N₂)
Nitrogen is used for clean, bright, oxide-free edges on stainless steel and aluminum. It does not react with the metal; it blows the melt out of the kerf. This requires high pressure and greater gas consumption. The resulting edge is ready for welding or painting without further treatment.
Compressed air
Compressed air is the most economical option, particularly for thin to medium-gauge sheet. The air must be dry, oil-free and well filtered. Some light oxidation may appear on the edge.
Which gas suits each material?
| Material | Typical choice | Notes |
|---|---|---|
| Mild steel (thick) | Oxygen | Thick cutting at lower power; oxide on the edge |
| Mild steel (thin) | Oxygen or air | Air is economical and fast |
| Stainless steel | Nitrogen | Clean, bright edge |
| Aluminum | Nitrogen | Clean edge |
| Galvanized sheet | Nitrogen or air | Air may be sufficient for thin sheet |
Gas choice and pressure settings depend on the machine, laser power and material thickness.